STM32F100RET6B, ARM cortex M3, 24МГц, 512 флэш

STMicroelectronics

STM32F100RET6B

950,57

р.

The STM32F100RET6B is a high density access line STM32 F1 series 32-bit Microcontroller incorporates the high-performance ARM Cortex-M3 RISC core operating at a 24MHz frequency, high speed embedded memories (Flash memory up to 512kB and SRAM up to 32KB) and an extensive range of enhanced peripherals and I/Os connected to two APB buses. This device offer one 12-bit ADCs, two 12-bit DACs, up to nine general purpose 16-bit timers and an advanced-control PWM timer, as well as standard communication interfaces - up to two I²Cs, three SPIs, one HDMI CEC, three USARTs and two UARTs. • 24MHz Maximum frequency, 1.25 DMIPS/MHz (Dhrystone 2.1) performance • Single cycle multiplication and hardware division • Flexible static memory controller with 4 chip selects, supports SRAM, PSRAM and NOR memories • LCD parallel interface, 8080/6800 modes • Clock, reset and supply management • POR, PDR and programmable voltage detector (PVD) • 4 to 24MHz Crystal oscillator • Internal 8MHz factory trimmed RC • Internal 40kHz RC • PLL for CPU clock • 32kHz Oscillator for RTC with calibration • Sleep, stop and standby modes • VBAT supply for RTC and backup registers • Serial wire debug (SWD) and JTAG interfaces • 12-channel DMA Controller • Two watchdog timers (Independent and window) • SysTick Timer • 96-bit Unique ID

Подраздел: Микроконтроллеры

Тип: Микроконтроллеры STM

Ядро: ARM Cortex-M3

Разрядность: 32 Бита

Тактовая частота: 24МГц

Интерфейсы: I2C, IrDA, LIN, SPI, UART/USART

Периферия: DMA, PDR, POR, PVD, PWM, Temp Sensor, WD

Число линий I/O: 51

Память программ: 512Кб (512К x 8)

Оперативная память: 32К x 8

Напр. питания: 2 В ~ 3.6 В

Корпус: LQFP64

Серия: stm32 f1

Количество входов/выходов: 51

Объем памяти программ: 512 кбайт (512k x 8)

Тип памяти программ: flash

Объем RAM: 32k x 8

Наличие АЦП/ЦАП: ацп 16x12b/цап 2x12b

Встроенные интерфейсы: i2c, irda, lin, spi, uart

Встроенная периферия: dma, pdr, por, pvd, pwm, tempsensor, wdt

Напряжение питания: 2…3.6 в

Рабочая температура: -40…+85c